How would you like to proceed?
CTF firmware will overwrite the standard firmware on all ECUs. The board can be restored using the post-CTF reset tool afterwards. For the best experience, consider using the Update RAMN mode instead.
This wizard flashes firmware to all four ECUs. Use this mode for a newly fabricated board, or to recover a board where ECU A is stuck in DFU mode.
ECU A must be in DFU mode before you begin. If it is not, use the Update RAMN mode instead.
This is a CTF challenge firmware. A few things to know before you proceed:
Default is Logarithmic — correct for most boards.
How to check if you have the wrong type installed:
This tool uses WebUSB (ECU A / DFU) and Web Serial (ECU B/C/D via CAN). These APIs are available in:
Firefox and Safari do not support these APIs.
The page must be served over HTTPS or localhost.